Konig Electronic USB turntable with speakers - Manual (Page 40)

40
• Check the microphone slider to make sure that it is at full volume, all the way to the right as shown
below: If you are not seeing the microphone slider, please go to the Preferences menu in Audacity,
click on the Interface tab and make sure that the Enable Mixer Toolbar and Enable Meter Toolbar
options are checked. If they are not, please check them and then press OK.
POOR SOUND QUALITY:
• Check your stylus connection to make sure it is secured to the tone arm. The stylus must be
connected to the tone arm whenever you are using the turntable.
• Make sure that your RCA plugs are plugged into a source or not touching bare metal. If you are
experiencing noise through the USB, you may have interference from the RCA plugs. Ensure the
USB cable is not touching or near any other cables.
• If you experience any odd sounds coming from the recording, try closing all applications and restart
them.
• Make sure that you have properly installed and calibrated the tone arm of the turntable.
Problem Cause Solution
THE WHOLE UNIT
The unit does not
power up when
the power switch is
pressed.
Unit is unplugged.
Connect the unit to the AC
power supply.
The sound is noisy.
The unit is too close to a
TV set or another similar
appliance.
Turn off the TV or other
appliance, and relocate the
unit.
The unit has no
response or could
not be reset.
External factors such as ESD
(Electro-static discharge)
affect the unit.
Remove the power cord and
all power supply devices, then
re-plug in the unit after one
minute.
PHONO PLAYER
The sound is noisy
when playing the
record.
The stylus is not placed in the
center.
Place the stylus in the center.
The sound is noisy
when used for a
period of time.
The stylus is damaged.
Please change to a new
stylus.
USB DEVICE/CARD ‘NO USB’ or ‘NO
CARD’ appears.
USB flash device or CARD
has not been inserted.
Connect a USB flash device or
a card into the corresponding
slot.
The format is incorrect.
Backup all the files in your
computer and format the USB/
CARD and try again.
TUNER UNIT
Cannot listen to any
station, or signal
appears weak.
The station is not tuned-in
properly.
Properly tune-in to the desired
station.
A TV set is being used nearby
and is interfering with the radio
reception.
Turn off the interfering TV set.
The sound is
distorted.
The antenna is not oriented
properly.
Re-orient the antenna until
reception improves.