Kipp&Zonen SOLYS 2 Sun Tracker - Manual (Page 56)

8.2 FAQ
Q: I have a problem with the aligning the SOLYS
A: Proper placement of the SOLYS 2 is important when installing it, as it requires a specific amount of free
space to operate.
Make sure the tripod is placed on a solid base.
Keep in mind that final alignment is only possible when the sun is shining.
The following 8 steps are required to align the SOLYS 2. in the previous paragraphs additional
information is available for each step.
1. Position the tripod with the K&Z logo pointing East.
2. Put the SOLYS 2 on the tripod with the E-marking on the bottom flange pointing East.
3. Put the M8 bolts in by hand but do not tighten them yet.
4. Level the SOLYS by adjusting the tripod feet and checking the bubble level.
5. Connect power to the SOLYS 2 and let it move to its home position.
6. Wait until the green status light is on to indicate the correct GPS position is received.
The SOLYS 2 will now rotate to the sun position.
7. Rotate the SOLYS on its tripod (adjust azimuth) until the alignment target from the bracket points
exactly at the sun.
8. Fasten the M8 bolts
9. The side mounting plate is adjusted in the factory and need no adjustment.
10. If the side mounting plates have been loosened or removed adjust the zenith position as well until
the alignment target points at the sun and fasten the screws in the side mounting plates.
Q: It seems we can move the tracker by hand. Is this allowed?
A: Moving the SOLYS by hand or blocking it, when powered is enabled, can DAMAGE the belt drive!
When doing this please consider the following:
-Power should be disconnected
-Turning should be done very slowly
-Turning should be done using minimum amount of force.
Q: How to guide the cables and what is the advised cable legth.
A: At initial start-up, the SOLYS 2 will make a 540 degree rotation lap. This is checking if the cable length
is sufficient.
Chapter 15 has a drawing which indicates how to guide the cable.