HITEC Sky Scout (2GO) - Manual (Page 20)

20
Fly high with Hitec
Section Seven: Repair and Maintenance of Your Model
17. Attaching the servo well covers
Press the left and right servo well covers 11 and 12 into the openings in
both sides of the fuselage. They should not be glued in place, as you may
have to replace the servos at some time.
20. Installing the motor
Fix the motor in place using two M3 x 6 screws. Apply a drop of medium-
strength thread-lock fluid to the screws.
21. Installing the motor cowl
Fit the three screws 30 to secure the motor cowl 41.
18. Installing the firewall
Glue the firewall 40 in place using thick CA glue. Don’t use activator for
this joint, as you will need a certain amount of time to position and align
the firewall correctly.
19. Gluing the cowl screw support in place
Glue the cowl screw support 42 at the front end of the motor pod.
22. Completing the canopy
Glue the latch tongues 28 in the recesses in the canopy 5.
Use thick CA glue initially, and fit the canopy on the model immediately,
so that the latch components align themselves automatically. Wait for at
least two minutes before removing the canopy, then apply drops of thin CA
glue to the gaps in the latches to glue them in place, flush with the foam.