HITEC S60 - Manual (Page 38)

74 75
8. When the camera is in use over a long time, the temperature of the
metal parts near the lens may rise. This is a normal phenomenon,
but please do not touch the heated metal parts.
9. Hot plugging is not supported. If the screen goes white, please
restart the camera to return to normal.
10.The main unit can be operated normally during charging, but this
may reduce the service life of both the battery and the device.
FCC Notices
1.The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user's authority to operate the
equipment.
2.This device complies with Part 15 of the FCC Rules. (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.