HITEC S60 - Manual (Page 31)

60 61
Startup
Long-hold the "Power / Record" button for 5s to start the Wi- Fi based
remote control.
After startup, the screen will display the battery icon "
." If the
battery icon is empty, it indicates that the battery level is low and
charging is needed; please connect the USB power supply to the
USB port of the remote control for charging.
Pairing
Please complete the pairing process before enabling the remote
control functions. Steps for pairing between the Wi-Fi based remote
control and the camera are as follows:
1. Turn on the camera and activate the Wi-Fi function.
2. First, press and hold the "Stop" button on the Wi-Fi remote control.
Next, long-press "Power / Record" for 5s to start the remote
control. The red power indicator will stay on and the screen will
display the battery icon "
."
3. Long-press the "Power/Record" and "Stop" buttons and do not
release them until the WAIT HOST PBC" icon appears.
WAIT HOST PBC
4. Press the "Stop" button on the camera once and the Wi-Fi remote
control screen will display the icon below:
PRESS CONNECT
5. Press the "Stop" button on the Wi-Fi remote control and the
remote’s screen will display the icon below:
info SYNC
CONNECT
6. When the remote control enters the recording standby state and
the following interface, code pairing is successfully completed:
100-088
2H30
1080P- 25
1
5 6
2
3
4
7
1
2
3
4
100-0088
1888
8M