Hamilton Buhl LyteBoard - Manual (Page 39)

Buhl LyteBoard IWB User Guide V.12/7/09
Page 39 of 43
www.buhl-ind.com
Notice: Keep the resolution at 1024﹡768 and turn off all of the Energy-saving way in
order to avoid delay from dormancy. When the Whiteboard is not in use, please pull out
the data line between Buhl IWB and PC.
5.2 Caution
1. The surface material of Buhl IWB Series Interactive Whiteboard is divided into two
kinds: One can be written by general pens and if Whiteboard are dirty or leave ink marks,
please use alcohol or machine water to wipe the surface of Whiteboard with a soft cloth .
The other can not be written by general pens. It'd best to exit computer's operating
system and switch projector to standby mode before cleaning, so that stains will be shown
clearly. General stains can be erased easily by water or general cleanser with paper.
Please do not wash by water directly, so as to avoid short-circuit.
（Wipe the white board
with spill free wet cloth
）
Notice:
1. The sensors around the whiteboard can not be blocked by any objects, and keep
surface blankness without any protuberant objects or avoid distortion.
2. Avoid laying the data cable on the floor in order not to stumble. (Please straighten the
data cable and fix it with an isolated tape which has warning color, in case that the data
cable must be laid on the floor.) the cable should not bend in any case during operating.
USB line should be keep properly from damage. If the Whiteboard is installed in
conference rooms, classrooms or other related environmental, you should fix-up the USB
line in line’s groove.
3. handle the Buhl IWB with care, no extra weight applied on the Buhl IWB or
penholders, Do not hit, shake heavily, and to avoid short-circuit. Do not squeeze or