4. black mark paper – GoDEX EZDT4 User Manual
Page 32

5-4. Black Mark Paper
W
aper width is equal to the maximum width of
p
18mm for EZ-DT-4), the error may occur since the
b
e detected by sensor sometimes. In this
c
mark conform to below limitations.
E
hen printing with Black Mark paper which p
rinter's acceptability (60mm for EZ-DT-2; 1
lack mark on reverse side of label cannot b
ircumstance, please make sure the black
Z-DT-2
I
r is 60mm, the size and location of black mark should be:
length of A is more than 13.1mm
f the width of black mark pape
z
z
length of B is less than 5mm
z
length of C is more than 8.1mm
EZ-DT-4
If the width of black mark paper is 118mm
length of A is more than 10.05mm
length of B is less than 1.95mm
, the size and location of black mark should be:
z
z
z
length of C is more than 8.1mm
EZ-DT-2/EZ-DT-4 User’s Manual
31