GoDEX EZDT4 - Manual (Page 19)

3-2. Cutter Module Installation
1 Cutter Module
2 Screw x 2pcs
2
1
【Note1】
Please power off the printer
before installing the cutter
module.
【Note2】
Do not cut self-adhesive labels!
The traces of adhesive will
pollute the rotary knife and
impair safe operation! The
service life of the cutter is
1,000,000 cuts for paper
weights up to 120g/
㎡, and
500,000 cuts for paper weights
120g/
㎡ to 170g/㎡.
【Note3】
The max paper cutting width is 114mm
【Note4】
The label / paper that used for cutting is suggested to be at
least 30mm (for DT-4) and 40mm (for DT-2) in height.
1. Place the printer on a
horizontal surface and
open the Top Cover.
2. Remove the Front Cover
Piece.
3. Push the Cutter connector
into printer through the
cable hole as shown in
figure.
4.
Place the Stripper on the
fillister.
EZ-DT-2/EZ-DT-4 User’s Manual
18