Glow-worm Climapro2 RF - Manual (Page 17)

0020094586_01 - 08/10 - Glow-worm
- 15 -
INSTALLATION
10.8 Radio
Menu This menu lets you:
Establish the connection between the radio
receiver and the room thermostat.
Test the quality of the radio signal
(thermostat and wireless outdoor sensor).
10.8.1 Pairing
This function lets you perform the pairing between the
thermostat and the radio receiver.
• From the installer menu (see access to the installer menu) >
select on the screen > Rf > pairing
10.8.2 Test
This function lets you test the quality of the signal between the
room thermostat and the radio receiver.
In the case where a wireless outdoor sensor is included in
the heating system, the room thermostat will also indicate the
quality of the signal between the outdoor sensor and the radio
receiver.
Wait about fifteen minutes after activating the
thermostat and the outdoor sensor before testing.
Signal Quality Comment
Excellent
Normal functioning
Average
Poor
Operating limit*
Null Inoperative*
(*) Check the room thermostat’s batteries (see the
instructions). If the signal quality does not improve.
Change the location of the appliances, reducing
distances and removing obstacles.
• From the installer menu (see access to the installer menu) >
select on the screen > Rf > test
11 Control / Commissioning
After installing the room thermostat:
• Turn on the appliance according to the operating instructions
and check for correct operation.
12 User information
At the end of the installation:
- explain the operation of the appliance and its safety devices
to the user, if necessary provide a demonstration and answer
any questions;
- give the user all the required documentation,
- fill in the documents where necessary;
- advise the user of the precautions necessary to prevent
damage to the system, appliance and the building;
- remind the user to service the appliance annually.