Glow-worm Climapro2 RF - Manual (Page 12)

0020094586_01 - 08/10 - Glow-worm
- 10 -
INSTALLATION
9 Commissioning
9.1 Appliances included in the installation
• Switch on the appliances that make up the installation (see
the installation manuals).
9.2 Room thermostat
B
A
C
1
3
2
4
5
Legend
1 battery cover
2 batteries
3 Insulating strip
4 battery compartment
5 Room thermostat
• Remove the insulating strip (3) located in the battery
compartment, respecting the order of operations (A) to (C).
• Perform the pairing of the room thermostat based on your
installation (see Chapter pairing).
10 Specific settings
Accessing the room thermostats installer menu allows for some
adjustments to be made to the installation (room thermostat and
remote sensor) and the room thermostat’s user menu.
10.1 Main settings
function Title Action
Heating Maximum
room
temperature
Choose a value between 5 °C and
30 °C. (factory setting: 30 °C).
Room
temperature
correction
Choose a value between -5 °C
and 5 °C with a step of 0.5 °C.
(factory setting: 0 °C).
Modulating
control
Activate (ON) or deactivate (OFF)
(default setting: OFF).
Hot water On/Off Activate (ON) or deactivate (OFF)
(default setting: ON).
Maximum
temperature
of domestic
hot water
Choose a value between 38 °C
and 65 °C. (factory setting: 60 °C).
Program Enable (YES) or disable (NO)
(default setting: ON).
Cooling function On/Off Activate (ON) or deactivate (OFF)
(default setting: OFF).
Program Enable (YES) or disable (NO)
(default setting: OFF).
Options
(outdoor
sensor)
Adjustment
possible only
if an outdoor
sensor is
connected
Outside
temperature
correction
Choose a value between -5 °C
and 5 °C with a step of 1 °C.
(factory setting: 0 °C).
Choosing the
heating profile
Choose a value between 0.2 and
4. (factory setting: 2).
See the instructions for the
outdoor sensor connected to
the appliance to carry out this
adjustment.
Note : the settings for the outdoor
sensor made on the appliance will
no longer be active.