FeiYu Tech FY-41AP - Manual (Page 24)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 22
The default Gimbal Gain:Roll 50,Pitch 50.
Under the condition of servo no rotation, you should control the camera gimbal with
the RC stick. If the servo is shaking when the stick in th
e neutral position, that‘s indicates
the sensitivity is too much. As a result, you should slowly decrease (10% -20% each time)
corresponding direction Gimbal Gain, until the shaking situation disappears. If the camera
gimbal goes back to Neutral, it is too soft. As a result, you should slowly increase (10%
-20% each time) corresponding direction Gimbal Gain
(3) Gimbal Neutral
The default Gimbal Neutral is 1520.
Power on and put the camera gimbal into level position, observe the servos position.
If the servos is not in the Neutral value, please thoroughly adjust the corresponding servos
Gimbal Neutral to put them into Neutral value position.
Adjusting method: According to corresponding servo reaction, appropriate increase or
decrease corresponding servo Gimbal Neutral.
13.13 FAIL-SAFE Setting
In order to realize auto return to home when your aircraft out of control, requires your
RC and RC receiver both have ―Fail Safe‖ function.
When the Failsafe remote control receiver doesn‘t receive a signal, it outputs a
default setting for the rudder. Most remote control models have a controlled set runway
protection system. Please refer to your remote control‘s manual to see if your remote
has this function.
Auto return to home when your aircraft out of control require you connect the SW1 to
RC receiver CH5 corresponding channel and adjust your RC to make RC receiver CH5
channel output a out of control signal to make SW1 into RTH mode. And adjust your RC to
make RC receiver throttle channel output a out of control signal to make throttle into
hovering position.
If in debugging balanced mode, the following example is that of a Futaba remote
control T10CHG setting runaway protection. Go to the settings menu, then turn off the
power to the aircraft to avoid setting the motor to start without control.
First enter the remote control setup menu to find the set of "F / S"; into the F / S menu,
put the lever into the neutral position, carefully adjust the settings rudder to maintain the
status adjusted, put the throttle lever to the cruise throttle position, and then put the CH5
cut to return mode . Then in all open channel F / S set the program, as successfully shown
below (usually set by using the ―PUSH‖ button)