beautypg.com

EarthQuake 6040E User Manual

Page 20

background image

Operator's Manual

CRT Models 5040 and 6040E

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5 CST

0

Operator's Manual

CRT Models 5040 and 6040E

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5 CST

PRoBLEm

REmEdY/ACtion

Belts squeal in neutral and/or

reverse

• Adjust forward belt guide:
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark plug
- remove belt guard
- pull down on drive safety control levers

- manually bend forward belt guide so there is 1/16 inch or less clearance

between belt guide and belt

- replace belt guard and spark plug wire

Belts squeal in forward operation

• Adjust tabs on the reverse belt guide
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark plug
- release drive safety control levers to neutral position
- remove belt guard

- adjust tabs of reverse belt guide: while drive safety control levers are re-

leased, bend metal tabs on reverse belt guide to 1/64 inch or less clearance
from reverse belt

- replace belt guard and spark plug wire

Excessive heat build up in trans-
mission/tine area during tilling

• Remove vegetation by following instructions in Clean Tine Axle Shaft of

Normal Care section. FOLLOW ALL SAFETY INSTRUCTIONS

• Check transmission fluid and fill if needed

This manual is related to the following products: