EarthQuake 6040E - Manual (Page 12)

Operator's Manual
CRT Models 5040 and 6040E
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
1
Operator's Manual
CRT Models 5040 and 6040E
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
WhEEL LoCk PinS
Place wheels in tilling position.
1. Remove lock pin. Align hole in axle with hole in wheel
hub. (SEE FiGuRE 2)
. Insert lock pin through holes, fold lock pin ring to
secure pin to axle.
3. Firmly lock wheel and axle together before tilling.
4. Repeat for other wheel.
note: always have both wheel lock pins in or out.
Do not operate tiller with only one wheel locked.
To place wheels in free-wheel position.
1. Remove lock pin. Slide wheel inward toward machine.
. Insert pin in axle only.
3. Wheel should turn freely on axle.
hAndLEBAR hEiGht AdjuStmEnt
Adjust handlebar height.
The ideal height of the handlebar varies with operator
height and the depth of tilling. To adjust handlebar
height: (SEE FiGuRE 3)
1. Unscrew nuts and remove top and bottom bolts on
each side.
. Align handlebar to desired holes on the lower
handlebar mount.
3. Install bolts and nuts. Retighten.
Wheel lock pin in free-wheel position. (axle hole only)
height adjust-
ment holes
lock nuts
height adjust-
ment bolts
height adjust-
ment bolts
figure 2
WaRning
nEVER StARt EnGinE oR oPERAtE tiLLER
With WhEELS in FREE-WhEEL PoSition.
thE FREE-WhEEL PoSition iS FoR tRAnS-
PoRtinG thE tiLLER LonG diStAnCES oVER
LEVEL GRound--do not AttEmPt to moVE
thE tiLLER uP oR doWn StEEP GRAdES in
thE FREE-WhEEL PoSition.
figure 3