EarthQuake 6040E - Manual (Page 18)

Operator's Manual
CRT Models 5040 and 6040E
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
18
Operator's Manual
CRT Models 5040 and 6040E
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
LuBRiCAtion
Proper lubrication of moving mechanical parts is critical
for proper care and maintenance. Oil the moving parts
at 10 hour intervals using a 30 weight oil.
CLEAn tinE AxLE ShAFt
1. Turn off engine. Engine must be cool.
. Remove spark plug wire and secure from spark plug.
3. Tip the tiller forward. Block the tiller in position so
that it rests on the engine mount and the tines are
exposed.
4. Remove all vegetation, string, wire, and other material that
may have accumulated on the axle between the inside set
of tines and the seal on the transmission housing.
5. Tip the tiller back to a level position.
6. Replace spark plug wire.
StoRAGE
PREPARE FoR StoRAGE
Follow the steps below to prepare your tiller for storage.
Read your engine manual for detailed instructions on
preparing the engine for storage.
1. Protect wheels and axles from rust:
-Remove lockpin and slide wheel off hub.
-Coat the axles lightly with axle grease.
-Slide wheel back on hub and insert lock pin.
. Drain fuel system completely following engine
manufacturer’s instructions or add fuel stabilizer to
prevent fuel from gumming up during extended
storage period.
3. While engine is still warm, drain the oil from the
engine. Refill with fresh oil of the recommended
grade.
4. Clean external surfaces, engine and cooling fan.
5. Remove spark plug, pour one ounce of SAE 30 oil into
spark plug hole.
6. Plug hole and pull starter cord slowly to distribute oil
evenly in cylinder head area.
7. Reinstall spark plug.
WaRning
do not StoRE tiLLER in An unVEntiLAt-
Ed AREA WhERE FuEL FumES mAY REACh
FLAmE, SPARkS, PiLot LiGhtS oR An iGnit-
Ed oBjECt. dRAin FuEL outdooRS AWAY
FRom AnY iGnition SouRCES. uSE onLY
APPRoVEd FuEL ContAinERS.
8. Transport unit to a suitable storage location. If you have
chosen to use a fuel stabilizer and have not drained
the fuel system, follow all safety instructions storage
precautions in this manual to prevent the possibility
of fire from the ignition of gasoline fumes. Remember,
gasoline fumes can travel to distant sources of ignition
and ignite, causing risk of explosion and fire.
9. If there is any possibility of unauthorized use or
tampering, remove the spark plug and store it in a
safe place before storing the rototiller unit. Be sure to
plug the spark plug hole to prevent foreign material
from entering.