Eagle Tree Guardian 2D/3D Stabilizer User Manual
Page 14
Copyright 2013-2014 Eagle Tree Systems, LLC Page 14
Issue: When I increase the Gain on the Guardian, I see one or more control surfaces move, even though my model is level.
Solution: This can happen if the Guardian does not know your latest trim settings. Make sure you perform the “Reset Level Flight and Trims” or “Reset Level Trims”
operation (described above) each time you change your model’s trim settings.
Issue: My USB cable does not fit well in the Guardian’s USB connector.
Solution: We have received a few reports of tight-fitting USB cables. The Micro-B USB cable sold by Eagle Tree fits correctly, and we’ve also observed that Kindle
TM
USB cables and the mobile phone USB cables we have tested in-house fit well also. Note that “mini” USB cables will not fit!
Issue: I have performed a Reset Level Flight, but the AHI doesn’t seem to be accurate after moving the Guardian around and placing it flat again, or the model still isn’t
flying level, particularly after turn maneuvers.
Solution: This can sometimes be solved by using the “Rezero Gyros” button on the General page of the Guardian PC UI and carefully following the directions in the PC
software.
Regulatory
The Guardian has been tested with a typical installation and was found to comply with EU EMC requirements. As with any change or addition to an R/C system, you are
strongly advised to carry out a range and performance check before operating the equipment.
Limited Warranty
Eagle Tree Systems, LLC, (ET) warrants to the original purchaser (the Purchaser) that the purchased product (the Product) will be free from defects in materials and
workmanship for a period of one (1) year from the date of original purchase. This limited warranty is nontransferable.
This limited warranty does not cover problems that result from:
External causes such as accident, abuse, misuse, or problems with electrical power
Acts of God
Commercial use
Servicing not authorized by ET
Product not purchased from an ET authorized dealer
Usage that is not in accordance with the Product instructions
Failure to follow the Product instructions
OTHER THAN THE EXPRESS WARRANTY DESCRIBED ABOVE, ET MAKES NO OTHER WARRANTY OR REPRESENTATION OF ANY KIND, AND
HEREBY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF NON-
INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE PURCHASER ACKNOWLEDGES THAT HE OR SHE HAS
DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE REQUIREMENTS OF THE PURCHASER’S INTENDED USE.
Remedy of Purchaser
ET’s sole obligation and purchaser’s sole and exclusive remedy shall be that ET will replace or repair the Product, at our option. REPAIR OR REPLACEMENT AS
PROVIDED UNDER THIS WARRANTY IS THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY.
Limitation of Liability
ET SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION OR
COMMERCIAL LOSS IN ANY WAY, REGARDLESS OF WHETHER SUCH CLAIM IS BASED IN WARRANTY, CONTRACT, NEGLIGENCE, TORT, STRICT
LIABILITY OR ANY OTHER THEORY OF LIABILITY, EVEN IF ET HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Further, in no event
shall the ET’s liability exceed the retail sales price of the Product on which liability is asserted.
As ET has no control over setup, use, assembly, modification or misuse of the Product, no liability shall be assumed nor accepted for any resulting damage or injury. By the
act of setup, use, or assembly, the user accepts all resulting liability. If the purchaser or user is not prepared to accept the liability associated with the use of the Product, the
purchaser is advised to return the Product immediately in new condition to the place of purchase.
Obtaining Warranty Service
If the Product requires warranty service during this period, please email us at
or open a support ticket with us at
for further instructions.
All technical information in this manual is subject to change without notice. All non Eagle Tree brand and product names referenced in this manual are trademarks of
their respective holders.