Dream Property DM800 HD se - Manual (Page 60)

9. With the Navigation-Buttons ( ) choose the desired Satellite.
10. With the Navigation-Buttons ( ) choose the option “Port B”.
11. With the Navigation-Buttons ( ) choose the desired Satellite.
12. Press the OK-Button to save this settings.
Make sure you know which satellite is connected to which input on the Toneburst switch. If you do not find
any services in the transponder scan later, exchange the two satellites in this list and try again.
If you have trouble with “Tune failed” messages please set the “Send DiSEqC only on sattelite
change”
and “Set voltage and 22KHz” to “yes”.
7.1.4 Four satellites via DiSEqC A/B/C/D
Use this type of configuration if you want to receive four satellites from one Single Universal or Twin
Universal LNB for four or eight parties. It does not matter if you use one or two dishes to achieve this.
In this case the LNBs are connected to a so-called Multiswitch from which the signal is via coax cabled to
the satellite receivers (Dreamboxes) in your household.
Four satellites via DiSEqC A/B/C/D
Follow this steps:
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “Service searching” and press the OK-
Button
.
4. With the Navigation-Buttons ( ) choose the option “Tuner configuration” and press the OK-
Button
.
5. With the Navigation-Buttons ( ) choose the option “DVB-S2 Tuner” and press the OK-Button.
6. With the Navigation-Buttons ( ) choose the option “Mode”.
55