Dream Property DM800 HD se - Manual (Page 19)

2.2 Turning the device on
1. Place the batteries inside the battery compartment of the remote control keeping in mind the right
polarity.
2. Plug in the power cable into the supplied power supply and connect it to the Dreambox. The power
plug has to be plugged into a 110V/60Hz or 230V/50Hz power socket.
3. Now turn on your dreambox.
If you are using a switchable power socket please shutdown your Dreambox into deep standby before switch-
ing off the power socket. Detailed information can be found under Chapter
3.1 Turning your Dreambox on
and off
on page 16 .
Please note that the factory setting for the video format is CVBS (FBAS).
2.3 Start wizard
If you switch on your Dreambox for the first time, you will see the setup wizard. The setup wizard will
guide you through the first time installation. Follow the instructions on the screen and use the Navigation-
Buttons (
)
and the OK-Button. With the red Options-Button you can choose the desired
language.
Video output selection
You will be shown different video output modes for roughly 10 seconds, after you have connected and
switched on your Dreambox. Once you see a clear picture on your TV screen press the OK-Button to
select it. If you prefer a different output than the selected one you can use the Navigation-Buttons (
)
and the OK-Button to select it.
Language selection
With the Navigation-Buttons (
)
choose your desired langugage and confirm with the OK-Button.
14