Dream Property DM800 HD se - Manual (Page 42)

4. Now remount the hard disk cage in your Dreambox and ensure the correct fitting of the hard disk cage
connector to the slot on the mainboard. Then tighten the hard disk cage with 2 screws to the housing
of the dreambox (see figure).
Fit hdd cage to dreambox housing
5. Reassamble your Dreambox by following the guide (siehe Punkt
5.1 Opening the device
on page 34 )
backwards.
6. Reattach all necessary cables to your Dreambox making sure that you connect the power cord as last.
Before you can use your hard disk for recordings it has to be initialized by the box as described in
Punkt
5.2.1 Initialization
on page 38 .
5.2 Management
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “System” and press the OK-Button.
4. With the Navigation-Buttons ( ) choose the option “Harddisk” and press the OK-Button.
5. With the Navigation-Buttons ( ) choose the option “Harddisk setup” and press the OK-Button.
You now can set the duration of time after which the harddisk will be put into standby-mode. You can
select from:
• No standby
• 10 or 30 Seconds
• 1, 2, 5, 10, 20 or 30 Minutes
37