Dream Property DM800 HD se - Manual (Page 53)

Mode
Scart
Select the standard supported by your TV screen. This is usually either PAL or NTSC. If you own
a TV screen which supports both modes you can also select the Multi option. Your TV screen will
automatically switch depending on the input signal. These options are only available ifthe output type
is set to “Scart”.
Aspect ratio
Automatic (Standard)
4:3 shows will be shown as 4:3 and 16:9 shows will be shown as 16:9.
4:3
Display 16:9 content as:
Letterbox
16:9 programs will be displayed on 4:3 TV’s with black beams at top and bottom.
Pan&Scan
16:9 programs will be zoomed to full hight on 4:3 TV’s, parts of the picture on the left and right
side will cut off.
Just Scale
4:3 shows will be shown in full height on a 16:9 screen and are stretched to fit the width of your
screen.
16:9 and 16:10
Display 4:3 content as:
Please see previous page
Color format
• RGB (Red, Green, Blue separated) Recommended setting for scart connection.
• S-Video (Color- and Brightness signal separated)
• CVBS (FBAS)
WSS on 4:3
Check the checkbox to disable zooming on some 16:9 TV’s during 4:3 transmissions.
6.5 OLED-Display
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “System” and press the OK-Button.
4. With the Navigation-Buttons ( ) choose the option “Display Setup” and press the OK-Button.
Now you can set the brightness of the OLED-display for standby and operation mode.
Operation
1. With the Navigation-Buttons ( ) choose the option “Operation”.
2. With the Navigation-Buttons ( ) choose the brightness of the OLED-Display for operation mode.
48