Digiframe DF-SC5701 User Manual
Page 20

- 16 -
Question: The System LED blinks rapidly and no scan is
possible.
Answer: Check the following:
Is the memory card inserted properly into the memory card
slot? Re-insert the card and try again.
Is the SD card locked (set to write-protect)? Unlock the card.
(small switch on side of SD card)
Is the memory card full? The indicator blinks when the free
space on the memory card is below 1MB. Use another card if
necessary.
Make sure the memory cards are in FAT or FAT32 file formats
only, not NTFS or any other file format.
Did you insert the next original before the scanning process of
the previous one was completed? Power the scanner off and
back on and try again. Make sure that you scan the next
original only after the scanning process of the previous one
has completed.
Does the length of the original exceed the maximum
acceptable size?
Question: The scanner feels warm to the touch.
Answer: It is normal for the scanner to emit a small amount of
heat (around 30-45 Celsius) after prolonged use. However, if
there are strange odors coming from the scanner or the
scanner feels hot to the touch, disconnect the scanner
immediately from the power supply or the computer.