Cino L780BT HC - Manual (Page 84)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Appendix
77
System Commands
PROGRAM
(Enter Programming Mode)
Save Configuration
Sleep
FIN (Finish) Clone
Paging
END
(Exit Programming Mode)
Factory Default
PowerTool Host Link
System Information List
(SYSLIST)
Master Default
Factory Default: After scanning” Factory Default” command, all parameters will be returned to factory default value (The radio link will be disconnected and the
scanner will revert to uninstall state).
Master Default: After scanning “Master Default” command, the scanner will remain the pre-set parameters of Host Interface Selection, Keyboard Interface
Control (except Record Suffix; Preamble; Postamble), Serial Interface Control (except Record Suffix; Preamble; Postamble), Wand/Laser Emulation Control,
Bluetooth Device Name, Bluetooth PIN Code, and Out-of-range Scanning, the rest of parameters will be returned to default value (The radio link is still keep
on).
Save User Default User Default
User Default: After scanning” Save User Default” command, all current parameters will be stored to the flash memory. Once you change the parameter and
would like to return to previous setting, please scan “User Default”.