Cino L780BT HC - Manual (Page 64)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
57
PROGRAM
Operation Control
♦ Out-of-range Scanning, Sleep Time-out Control ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Out-of-range Scanning SS
SS Disable
Enable 0
1
Link Supervision Time-out SS
SS
SS
SS
SS 1 sec
3 secs
5 secs
7 secs
9 secs
Only available in PAIR & PICO modes 0
1
2
3
4
Sleep Time-out of Connect State SS
MS
6 (x5) minutes
0-99 (x5) minutes
If you don’t want the scanner to enter sleep mode, please set time-out to “0” FIN
(2 digits)
Sleep Time-out of Disconnect State SS
MS
1 minute
0-99 minutes
If you don’t want the scanner to enter sleep mode, please set time-out to “0” FIN
(2 digits)
Out-of-range Scanning When radio link is built between the scanner and remote host device, the scanner will transmit each scanned data right after scanning the barcode
data. However, the scanner is preset for unable to scan any barcode data when it loses the radio connection. You can enable the Out-of-range Scanning function to
continue scanning barcode data into memory buffer until radio link resumed.
The Link Supervision Time-out is a pre-defined radio link supervision timeout setting. The scanner will supervise the radio link status every preset seconds.
The Sleep Time-out Control can be set under radio connection or disconnection state. If the scanner is not used within the preset time-out duration, it will automatically
enter “Sleep State” for power saving purpose. You are able to disable this function by setting the time-out duration to “0”.