Cino L780BT HC - Manual (Page 56)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
49
PROGRAM
Wand/Laser Emulation Control
♦ Code 39/Code 128 Emulation ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Output Polarity SS
SS High level (5Vdc) on Bar (low level on Space)
Low level (0Vdc) on Bar (high level on Space)
Determine the output voltage level for both bar and space.
0
1
Initial Signal State SS
SS High Level (5Vdc)
Low Level (0Vdc)
Determine the initial state of output voltage level.
0
1
Margin Time SS
SS
SS
SS 10 msec.
15 msec.
20 msec.
25 msec. 30 msec.
50 msec.
100 msec.
Delay time before data transmission 0
1
2
3 4
5
6
Module Time SS
SS
SS Extremely short
Short
Medium Long
Time base of minimum narrow bar
0
1
2 3
Narrow/Wide Ratio SS
SS
SS 1:2
1:2.5
1:3 0
1
2
Code 39/Code 128 Emulation SS
SS
SS
SS
SS Disable standard Code 39 emulation
Enable standard Code 39 skip emulation
Enable standard Code 39 replace emulation
Enable Full ASCII Code 39 emulation
Enable Code 128 emulation 0
1
2
3
4
[ Code 39 Skip] : When this option is selected, all scanned data will be translated as Standard Code 39 wand/laser emulation output. If any lower case characters are read,
they will be translated to upper case characters. Any other characters that are not available in Code 39 symbology set will be skipped.
[ Code 39 Replace] : Any character not normally available in the standard Code 39 symbology set, will be translated as Space.