Avalue EBM-CX700 - Manual (Page 74)

EBM-CX700 Series
74 EBM-CX700 Series User’s Manual
3.5.6.4 IRQ Resource
When resources are controlled manually, assign each system interrupt a type, depending
on the type of device using the interrupt.
This item allows you to determine the IRQ assigned to the PCI bus or reserved.
The Choices: PCI Device, Reserved.
3.5.6.5 PCI / VGA Palette Snoop
Leave this field at Disabled.
The choices: Enabled, Disabled.
3.5.6.6 Assign IRQ For VGA
While the system has one VGA controller and more than one VGA devices are connected,
then “Enabled” is set. If the system VGA controller is not used, then “Disabled” is set.
The choices: Enabled, Disabled.
3.5.6.7 Assign IRQ For USB
While the system has one USB controller and more than one USB devices are connected,
then “Enabled” is set. If the system USB controller is not used, then “Disabled” is set.
The choices: Enabled, Disabled.
3.5.6.8 Maximum ASPM Supported
This field is used to control the maximum level of supported ASPM on the given PCI
Express link on the system .
The choices: L0, Los, L1, L0s&L1.
3.5.6.9 Maximum Payload Size
This field is used to select the maximum TLP payload size of the PCI Express devices. The
unit is byte.
The choices: 128, 256, 512, 1024, 2048, 4096.
3.5.6.10 Maximum Payload Size
This field is used to select the maximum TLP payload size of the PCI Express devices. The
unit is byte.
The choices: 128, 256, 512, 1024, 2048, 4096.