Avalue EBM-CX700 - Manual (Page 71)

User’s Manual
EBM-CX700 Series User’s Manual 71
3.5.5.5 Suspend Mode
This setting defines the number of minutes before the system enters "suspend mode", the
deepest level of system inactivity shutdown. The exact definition depends on the system,
but in general this mode means that all system devices are shutdown (except for any that
the BIOS is specifically told to keep running) and the processor is shut down to a trickle
mode. .
The choices: Disabled, 1, 2, 4, 6, 8, 10, 20, 30, 40 Min, 1 Hour.
3.5.5.6 Video Off Option
This determines the screen off when system is in suspend mode.
The choices: Always On, Suspend Off
3.5.5.7 Video Off Method
This determines the manner in which the monitor is always on or turned off during suspend
mode.
The choices: Blank Screen, V/H SYNC+Blank, DPMS Support.
3.5.5.8 MODEM Use IRQ
This determines the IRQ in which the MODEM can use .
The choices: NA, 3, 4, 5, 7, 9, 10, 11.
3.5.5.9 Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state when the system has “hung”.(Only could working on ATX Power supply)
The choices: Delay 4 Sec, Instant-Off.
3.5.5.10 Run VGABIOS if S3 Resume
Select whether to run VGA BIOS if resuming from S3 state. This is only necessary for older
VGA drivers..
The choices: Auto, Yes, No.
3.5.5.11 Ac Loss Auto Restart:
This item is to set whether to run Ac Loss Auto Restart.
The choices: Off, On, Former-Sts.