AMT Datasouth Documax 5380 - Manual (Page 27)

- 27 -
PRINT DIR
Select the printing direction of the print head: unidirectional, bidirectional or Auto
selected via software.
HIGH DENSITY
After selecting this function, printing definition will be enhanced while the print
speed is reduce.
QUIET MODE
Disable or enable the low noise function. When this function is on, print speed will
be reduced.
AUTO LF
If this function is on, the printer will advance the paper one line automatically after
receiving every carriage return instruction.
LOADING
Specify the wait time between installing the cut sheet into the paper guide and
when it is fed into the printer. Choose to wait specify time or press LF/FF key to
feed paper.
EJECT Specify paper eject direction when loading paper from front.
PIN SWITCH
After selecting this function, the printer will switch different pins to print table line
automatically.
MARGIN DETECT
After selecting this function, the printer will detect the paper edge automatically
after feeding paper, and start to print from the position according to the left margin
setting.
SKEW DETECT
After selecting this function, the printer will auto detect paper skew when feeding
cut sheet paper. If the slant degree is beyond the set parameter, the printer will
eject paper automatically.
BAUD RATE Specify the printer serial data transfer rate.
PARITY Specify the parity bit for serial data transfer.
DATA BITS Specify the serial data bits.
STOP BITS Specify the serial data transfer stop bit.
PROTOCOL
Specify the protocol of printer serial data transfer as software control (XON/XOFF)
or hardware control (DTR).
Select the broken pin. The printer will automatically replace it with other pin to
print.