Alwarerc Eagle Pro V4 Camera 3-Axis 360D Panning Gimbal - Manual (Page 11)

Check the parts for Part 2 like the picture. Instal all the Alu Rod with the Outer Frame use
M2x6mm screws.(Part No.: 1, 7)
Stick the Alu Main Shaft Block with the Outer
Frame.(Make sure the direction of Alu Main Shaft
Block is correct.) using M2x5 Screws.
Insert the Flange Bearings and Nylon Washer to
the Alu Rods.(Part No.: 2, 4, 13)
Install the Alu Roll Bearing shaft to the Outer
Frame using M2x6mm Hex Cap Screws and
washers for two upper holes(shown on next step).
Add the washer on the place like the picture.
11