ADLINK M-342 - Manual (Page 62)

48 BIOS Setup
Atomic0p Requester Enable
If supported by hardware and set to "Enable", this function initi-
ates Atomic0p Requests only if the Bus Master Enable bit is in
the Command Register Set. Options: Disabled, Enabled.
Atomic0p Egress Blocking
If supported by hardware and set to "Enable", outbound
Atomic0p Requests via Egress Ports will be blocked.
Options:Disabled, Enabled.
IDO Request Enable
If supported by hardware and set to "Enabled", this permits set-
ting the number of ID-Based Ordering (IDO) bit (Attribute [2])
requests to be initiated. Options: Disabled, Enabled.
IDO Completion Enable
If supported by hardware and set to "Enabled", this permits set-
ting the number of ID-Based Ordering (IDO) bit (Attribute [2])
requests to be initiated. Options: Disabled, Enabled.
LTR Mechanism Enable
If supported by hardware and to "Enable", this enables the
Latency Tolerance Reporting (LTR) Mechanism. Options: Dis-
abled, Enabled.
End-End TLP Prefix Blocking
If supported by hardware and set to " Enable", this function will
block forwarding of TLPs containing End-End TLP Prefixes.
Options:Disabled, Enabled.
Target Link Speed
If supported by hardware and set to "Force to 2.5 GT/s" for
Downstream Ports, this sets an upper limit on Link operational
speed by restricting the values advertised by the Upstream
component in its training sequences. When "Auto" is selected
HW initialized data will be used. Options: Disabled, Enabled.