ADLINK M-342 - Manual (Page 49)

Driver Installation 35
M-342
4 Driver Installation
This chapter provides information on how to install the M-342
device drivers under Windows XP. The device drivers are located
in the following ADLINK All-in-One CD directories:
Follow the instructions below to install the required M-342 drivers:
1. Install the Windows operating system before installing any
driver. Most standard I/O device drivers are installed during
Windows installation.
2. Install the Chipset driver by running the program
infinst_autol.exe in X:\CHIP\Chipset driv-er_intel_INF
_Update_Utility_All_WinOS.zip. Follow the instructions
given and reboot when instructed.
3. Install the Display driver and utilities by running the program
Setup.exe in X:\VGA\VGA_driver_intel_Integrated
_Graphic_Windows XP_32bit.zip. Follow the instructions
given and reboot when instructed.
4. Install the Ethernet driver by running the program
PROWIn32.exe in X:\LAN\Network_driver_Intel_Network
_Adapter for window XP 32-bit.zip. Follow the instructions
given and reboot if required.
5. Install the Audio driver by running the program WDM_R257.exe
in X:\AUDIO\Audio_driver_Realtek_Windows XP.zip. Follow
the instructions given and reboot if required.
Chipset X:\CHIP
Display X:\VGA
Ethernet X:\LAN
Audio X:\AUDIO
Rapid Storage X:\RAID
Mgmt. Engine X:\ME
NOTE: NOTE:
In order to enable AHCI mode, you must pre-install the Intel®
Rapid Storage Technology driver using the F6 installation
method described in F6Readme.txt. that can be found here:
X:\RAID\Floppy Raid Driver For Win XP 32bits.zip.