ADLINK ND-6063 - Manual (Page 71)

Command Set
• 63
Note : When you want to change the checksum or baud rate then the
DEFAULT* pin should be grounded at first.
@Example
User command: %0130400600
Response: !30
Item Meaning Description
% (Leading Code) Command leading code.
01 (OldAddr) Original address ID is 01H.
30 (NewAddr)
New address ID is 30H
(Hexadecimal).
40 (TypeCode) Digital I/O module.
06 (BaudRate) Baud rate is 9600.
00 (CheckSumFlag) 00 means checksum is disable.
Carriage return 0x0D.
Code Baudrate
03 1200 bps
04 2400 bps
05 4800 bps
06 9600 bps
07 19200 bps
08 38400 bps
09 115200 bps
Table 0-1 Baud rate setting code
Table 0-2 Check sum flag setting
7 6 5 4 3 2 1 0
Reserved
Must to be 0
Checksum
0 : disable
1 : enable
Reserved
Must to be 000000