ADLINK ND-6063 User Manual
Page 67
Command Set
• 59
Example 2: checksum is enable
User Command: $012B7
Response: !01400600AC
$ : LeadingCode
01 : Address
2 : Command (Read Configuration)
B7 : Checksum value
‘$’ = 0x24
‘0’ = 0x30
‘1’ = 0x31
‘2’ = 0x30
B7 = ( 0x24 + 0x30 + 0x31 + 0x32 ) MOD 0x100
‘!’ = 0x24
‘0’ = 0x30
‘1’ = 0x31
‘4’ = 0x34
‘6’ = 0x36
AC = ( 0x24 + 0x30 + 0x31 + 0x34 + 0x30 + 0x30 + 0x36 + 0x30
+ 0x30 ) MOD 0x100
Note : 1.There is no spacing between characters.
2. At end of command need a
3. Checksum is optional parameter.
3.1.4
Response of NuDAM Commands
The response message depends on NuDAM command. The response is
also composed with several characteristics, including leading code,
variables, and carriage return for ending. There are two kinds of leading
code for response message, ”!“ or ”>“ means valid command
and ”?“ means invalid. By checking the response message, user can
monitor the command is valid or invalid.
Note : Under the following conditions, there will have no response
message.
1. The specified address ID is not exist.
2. Syntax error.
3. Communication error
4. Some special commands does not have response.