Directed Electronics G322R - Manual (Page 44)

41 © 2 0 0 3 d i r e c t e d e l e c t r o n i c s , i n c .
Are the door inputs connected? Is the H1/6 blue wire connected
to the door trigger wire in the vehicle? Either the H1/5 green or
the H1/7 violet should be used instead. (See Primary Harness
Wire Connection Guide section of this guide.)
➤ D Doooorr iin np pu utt d dooeess n noott rreessp poon nd d w wiitth h tth hee p prrooggrreessssiivvee ttrriiggggeerr,,
b bu utt w wiitth h iim mm meed diiaattee ffu ullll aallaarrm m::
Does the Status LED indicate that the trigger was caused by the
shock sensor? (See Table of Zones section of this guide.) The
shock sensor, if set to extreme sensitivity, may be detecting the
door unlatching before the door switch sends its signal.
Reducing the sensitivity can solve this problem.
➤ T Th hee V Vaalleett ® ® //P Prrooggrraam m ssw wiittcch h d dooeessn n''tt w woorrkk..
Is it plugged into the correct socket? (See Plug-In LED and
Valet ® /Program/Program Switch section of this guide.)
➤ SSttaattu uss L LE ED D d dooeessn n''tt w woorrkk..
Is the LED plugged into the correct socket? (See Plug-In LED
and Valet ® /Program Switch section of this guide.)