Directed Electronics G322R User Manual

Page 22

step 12

Testing the system

With all the previous steps completed, the operation of the
system can now be tested.

■

Close all the doors and press the

button on the transmitter,

the system should chirp one time.

■

At this point the system will go through diagnostics, a 15 second

process in which the security system will analyze the status of all

connected zones.

■

After 15 seconds open the driver side door, the alarm should

emit a series of chirps to indicate a security breach, after several

chirps the system will go into full trigger and the siren will

sound.

■

At any point during the chirps or full trigger press the

but-

ton again and the system should turn off.

■

Rearm the system and test the remainder of the doors.

■

After testing the doors sit in the vehicle and close the doors,

rearm the system and after 15 seconds turn the key on, the sys-

tem will emit a series of chirps and then go into full trigger, at

this time attempt to start the vehicle it should NOT crank.

■

Press the

button on the transmitter to disarm the system

and cycle the ignition key off, on, off to reset the system.

■

Rearm the system, wait 15 seconds and lightly bump the tire

with your foot, the system should emit a series of chirps, kick the

tire a little harder and the system should go into full trigger.

■

Disarm the system.

This completes the testing, if all functions and zones do not

➜