Directed Electronics G322R User Manual

Page 42

interprets this pattern of triggers as false alarms. After the third

trigger, the NPC

™

ignores, or bypasses, that sensor or switch

(along with any other sensors or switches sharing the same zone)

for 60 minutes. If the bypassed sensor is triggered again while it

is already being bypassed, the 60-minute bypass period will start

over. This ensures that a sensor that is continually being trig-

gered will remain bypassed.

The vehicle doors are protected differently by NPC

™

. If your

security system is triggered by an open door for three, full 30-

second cycles (one and one half minutes), the system will bypass

the doors until the trigger ceases.

note: Arming and disarming the system does not reset the
NPC™. The only ways to reset a bypassed zone are for
that zone not to be triggered for 60 minutes or to turn the
ignition key on. When testing your system, it is impor-
tant to remember that NPC™ can cause zones to be
bypassed and appear to not work. If five chirps are heard
when disarming the system, NPC™ has been engaged.
To clear the NPC™ memory, simply turn the ignition
key on.