DAVIS DRIVERIGHT 600 8156VSS - Manual (Page 28)

24
Tamper Log
The following actions will be logged as a tamper attempt:
❏ The DriveRight 600 is unplugged (loses power)
❏ Five incorrect entries in a row for the Security Code
❏ DriveRight is plugged back into the car (Tamper is logged but
not displayed on the console)
❏ DriveRight is rebooted
When a tamper is logged, the word “TAMPER” appears on all screens
if the tamper light has been enabled using the software. Plus, the time
at which the tamper attempt occurred and the cause of the tamper is
stored in the tamper log. The last 10 tamper events can be down-
loaded, viewed and printed, using the DriveRight Vehicle Manage-
ment Software.
To clear the flashing TAMPER segment, enter the correct security
code (see “Security Code Screen” on page 18). The tamper indicator
is also cleared after data is downloaded.
Tamper Indicator (Current Readings Screen)
NOTE: All data in the DriveRight 600 is stored in “non-volatile” mem-
ory which means no data will be lost even if power is removed.
Battery Operation
The DriveRight 600 is designed to be taken out of your vehicle so
the data may be reviewed anywhere. If you disconnect the unit from
its power source (the vehicle) it will automatically switch to battery
power. The word BAT appear in the lower left corner of all screens
to indicate that you are running on battery power.
Battery Power Indicator
km/h
SPEED
ACCEL
G
DISTANCE
K m
CURRENT
Tamper Indicator Flashing
TAMPER
DAY.MO
km/h
MPH SPEED
ACCEL
G
DISTANCE
K m
CURRENT
Battery Indicator
BAT
DAY.MO
DR600 UG Rev B D008.fm Page 24 Thursday, April 17, 2003 7:17 AM