DAVIS DRIVERIGHT 600 8156VSS - Manual (Page 23)

19
NOTE: If the entered code is correct, the clear all log data
screen appears when you press MODE. If the entered
code is not correct, the word NO appears on the dis-
play. You may attempt to enter the correct code five
times before the unit returns you to the Current Read-
ings screen and activates the tamper indicator, if the
tamper indicator is enabled.
❏ Set or Change the Security Code
Use PLUS and MINUS to enter your current code (if you are
entering a security code for the first time, make sure 0000 is
entered). Press and hold SET/CLEAR until the word CHG
(change) appears on the display.
Change Security Code
Use PLUS and MINUS to enter the desired security code. When
finished, press MODE to save the new code and move to the Clear
Log Screen.
Clear Log Screen
The clear all log data screen allows you to perform a “total clear” func-
tion which erases all data for every trip in your log at once.
Clear Log Screen
NOTE: Accident and tamper log data cannot be cleared.
CODE
SETTINGS
CLEAR LOG
SETTINGS
DR600 UG Rev B D008.fm Page 19 Thursday, April 17, 2003 7:17 AM