DAVIS DRIVERIGHT 600 8156VSS - Manual (Page 24)

20
You have the following option from the Clear Log Screen:
❏ Clear all Log Data
Press and hold SET/CLEAR. The word CLR (clear)
appears in the display to indicate that the unit is preparing
to clear all log data. To protect against accidental clearing
of data, you must press and hold SET/CLEAR for 3 sec-
onds before the unit clears data.
Preparing to Clear Log Data
Continue to hold SET/CLEAR until the unit beeps and the word
CLR disappears from the display. This indicates that the unit is in
the process of clearing data. The unit beeps and the word dONE
appears in the display when the unit finishes clearing data.
Unit Finished Clearing Data
Alarm On/Off Screen
The Alarm On/Off screen enables you to toggle the DriveRight
600’s audible alarm on and off. When the alarm is on, the unit will
beep when any of the set limits is exceeded, as a warning to the
driver. Turning the alarm off will disable the beeping, though the
DriveRight 600 will continue to record violations of the set limits.
Alarm On/Off Screen
CLEAR LOG
SETTINGS
CLEAR LOG
SETTINGS
ALARM
SETTINGS
DR600 UG Rev B D008.fm Page 20 Thursday, April 17, 2003 7:17 AM