Cortelco 2750 - Manual (Page 23)

18
3. MEMORY SETTINGS
3.1. Memory Features
The 2750 can store up to 40 telephone numbers in its Personal Directory. These numbers can be dialed
by pressing”#” followed by the arrow buttons. Characters other than numbers and telephone features
may also be stored in the Personal Directory. See the sections below for more details.
3.1.1 Storing a hyphen into memory
To insert a hyphen into a stored number, press PAGE when a hyphen is desired. Hyphens are not dialed
but can make it easier to read a telephone number.
3.1.2 Storing a dialing pause into memory
To insert a pause into a stored number, press HOLD when a pause is desired. Each press of HOLD will
insert a 1.5 second pause. The display will show a “p” for each pause inserted.
3.1.3 Storing a flash into memory
To insert a flash into a stored number, press FLASH when a flash is desired. Each press of FLASH
will insert a 600 millisecond (ms) flash. The display will show an “f” for each flash inserted. The
flash time may also be changed to values other than 600 mSec.
Note: If 600ms is not an appropriate length for your installation, you may set a different value.
3.1.4 Storing temporary tone dialing into memory
To store a temporary switch to tone dialing in a memory location, press the * (TONE) button. All the
remaining numbers will be dialed in tone mode.
3.1.5 Storing one of the last five numbers dialed into memory
To store a dialed number, press REDIAL. Then press the UP or DOWN key to scroll through the last
five numbers dialed. When the desired number is displayed, press the Directory key (#) and press Yes
to save or No to cancel
3.1.6 Storing a Caller ID number into memory
To store a caller ID number, press CALLS. Then press the UP or DOWN key to scroll through the
Caller ID list. When the desired number is displayed, press the Directory key (#) and press Yes to save
or No to cancel.
3.2 To store a personal directory dial number
a. Press MENU. The display will read “Phone Setting”
b. Press DOWN ARROW until “Memory Setting” appears in the display
c. Press the soft key under ENTER. The display will read “Select Location”
d. Press #. The display will read “ Empty Location,” or indicate that the personal directory is full.