Cortelco 2750 - Manual (Page 22)

17
d. Press the DOWN ARROW repeatedly until “Tone/Pulse” appears in the display. The display
will show the current tone/pulse setting.
e. Press the soft key under CHANGE repeatedly, to select either TONE or PULSE dialing.
f. Press MENU to exit.
Note: If the system is set to Pulse Dialing, press the * button to change the dialing mode temporarily to
tone during a call. This can be used to access services which require tone dialing. Dialing mode will
revert to pulse when the call ends.
2.11 Area Codes
The 2750 can accept three sets of Area Codes.
2.11.1 Home Area Code
This is the area code for the area where the 2750 is located. Only one Home Area Code may be
entered. After the Home Area Code is entered, only seven digits will be displayed when a call is
received from within the Home Area Code. Also, only seven digits will be dialed when REDIAL is
pressed.
2.11.2 Local Area Codes
These are area codes that require the area code plus seven digits to be dialed. A “1” is not dialed for
these area codes.
2.11.3 1 Plus 7
These area codes are for calls that require “1” plus the seven digits to be dialed. Up to six 1 Plus 7 area
codes may be entered. To enter area codes
a.
Press MENU. The display will read “Phone Setting”
b. Press the soft key under ENTER
c. Press DOWN ARROW until “Area Codes” appears in the display
d. Press the soft key under ENTER. The HOME area code setting will be displayed.
e. Press the soft key under CHANGE to change this setting
f. Press DOWN ARROW to view the LOCAL setting
g. Press the soft key under CHANGE to change this setting
h. Press DOWN ARROW to view the 1 PLUS 7 area code settings.
i. Press the soft key under CHANGE to change this setting