Cortelco 2750 - Manual (Page 18)

13
d. Press the soft key under CHANGE repeatedly, until the desired distinctive ring setting for Line
1 is displayed. There are eight choices.
e. Press the DOWN ARROW to see the current setting for Line 2, and repeat steps c and d to
change the settings for Lines 2-4.
f. Press MENU to exit.
Note: When a distinctive ring setting is displayed, it may be heard by pressing the soft key under
CHANGE.
2.5.3 Off-Hook Ringing
When a ringer is set to ON or DELAYED, an incoming call will cause a double ring every 15 seconds
is the phone is in use. This feature is called “off-hook ringing” and can be disabled. To disable off-
hook ringing
a.
Press MENU.
b. Press the soft key under NEXT repeatedly until “Off Hook Ring” appears in the display, along
with the current setting.
c. Press the soft key under CHANGE to change the setting.
d. Press MENU to exit.
Note: Off-Hook ringing does not function on intercom calls. However, the line lamps will flash to
indicate an incoming call.
2.6 Intercom Call Response
The 2750 may be configured to respond to intercom calls in one of three ways:
INTERCOM HANDSFREE: When an intercom call is received, the telephone will ring once and then
give a triple alert tone. The phone will then automatically answer the intercom call on speakerphone.
INTERCOM RING: When an intercom call is received, the telephone will ring repeatedly with the
intercom ring. The call may be answered by lifting the handset or pressing the SPEAKER button.
INTERCOM VOICE: When an intercom call is received, the telephone will ring once and then give an
alert tone. After this the calling party will be connected. To respond to the calling party, either lift the
handset or press the SPEAKER button.
Note: When an intercom call is received while an outside call is in progress, the 2750 will ring with a
single intercom ring regardless of the intercom ringer setting
2.6.1 Configuring intercom call response:
a. Press MENU. The display will read Phone Setting
b. Press soft key under ENTER.
c. Press the Down Arrow repeatedly until Intercom Prefs appears in the display.
d. Press soft key under ENTER. The display will show the current intercom setting.
e. Press the soft key under CHANGE repeatedly, until the desired intercom setting is displayed.
f. Press MENU to exit.