Bryant 463AAC012BA - Manual (Page 14)

Care and Maintenance
Wheri servicing the air conditioner, be sure to
turn the mode switch to the "OFF" position and
disconnect the power cord from the electrical outlet
1 DOT NOT uise gasoline, benzine, thinner or
other chemicals on the air conditioner as these
substances may cause damage to the paint finish
and deformation of plastic parts
2 Never attempt to pour water directly to the
front of the unit as this will cause deterioration of
the electrical insulation
Cleaning the Air Filter
Removal of Air Filter
If the air filter becomes dogged with dust, air-flow
is obstructed and reduces efficiency The air filter
should be cleaned once a month More frequent
cleaning may be necessary depending on outdoor
and indoor air quality
Air Filter Removal:
(Model 463AAC010BA)
A Remove the air inlet grille by sliding the grille
to the left
В Remove the air filter
Air Filter Removal.
(Model 463AAC012BA)
To remove the air filter, grasp the filter handle(tab)
located on the right (center) side of the air inlet grille
and slide the air filter to the right
To reinstall the air filter, reverse the above
procedure
CAUTION
DO NOT :^6fget to install the air filter If the air
conditioner is left to operate without the air filter^
cjust is nbt removed from the room and may
cauee ybiir air conditioner to fail
When the air filter inlet grill and cabinet are dirty»
wipe with lukewarm water (below
40° C) Use oT
mild detergent is recommended
Cleaning of Air Filter
1 Remove dust clogged in the filter by
tapping it or vacuum clean it
2 Wash the filter well with lukewarm water below
40“C (104 °F) while rubbing lightly To get better
results, wash it with soapy water or a neutral
cleaning agent
3 Rinse the filter well using clean water then
dry completely
End-of-Season Care
1 Operate the fan alone for half a day to dry out
the inside of the unit
2 Turn off power and remove plug from wall socket|
3 Clean filter
4 Store in a dry location
-
13
-