Bolens 140-990A - Manual (Page 8)

FIGURE?.
FIGURES.
■■■*:•> 7:-^: VN
h - ...... ..........- d
2. Assemble each draft bar to the axle brackets
using the longest clevis pins, two large
washers, and secure with a cotter hairpin.
—(See figures 7 and 8.)
NOTE
Refer to figure 9 to determine which
is the right and left draft bars.
3. Attach the flat end of the pull rod to the top
hole in the draft bar with the shorter clevis
pin, flat washer cotter hairpin. (See figure 7.)
4. Assemble the draw bar to the draft bars and
secure each end with a cotter hairpin. (See
figure 9.)
5. Screw one hex nut all the way on to each of
hook bolts.
FIGURES.
6. Place a lock washer next to the hex nut and in­
sert the hook bolt through the inside of the
draft bar. Secure using a second nut. Do not
tighten. (See figure 9.)
7. Fasten the chains to the hooks welded on the
draft bars. Cross the chains over and attach to
the opposite hook bolts.
NOTE
Pull the chains to make them as
tight as possible.
8. Tighten the outside nuts on the hook bolts un­
til there is approximately one inch of play in
the center of the chains.
9. Tighten the inside nuts on the hook bolts.