Pull rod, Warning, Assembling the three point hitch – Bolens 140-990A User Manual

Page 7: Note

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

2. Attach the positive battery cable (which has

two wires) to the positive battery terminai.

— (See figure 4.)

3. Attach the negative battery cable (grounded,

single wire) to the negative battery terminal.

FIGURE 4.

Pull Rod

Clevis End

■

321/2

Assemble the hold down rods (B) and hold
down (A) before you place It over the battery

(see figure 5) using wing nuts (D) and flat
washers (C).

Place the battery hold down assembly over

the battery and slide the battery into place.

(See figure 4.)

WARNING {

Place the hold down on the side op
posite the terminals.

6. Hook the hold down rods into the battery case

and tighten fingertight. (Do not overtighten.)

ASSEMBLING THE THREE POINT HITCH

NOTE

FIGURES.

Use the three point hitch only for

the rear attachments such as the
moldboard plow, disc and cultivator.
If you are using the mowing deck,
snow blade or snow thrower it is not
necessary to attach the three point
hitch.

1. Adjust the clevis ends on both pull rods so

that they measure 32Va inches. (See figures.)