Audio adjust, Graphi, Volume – Aiwa CX-NA303 User Manual
Page 7: Super t-bass system, Press one of graphic equalizer, To cancel the selected mode, To select with the remote control, To dim the illumination of the display, Using the headphones, Sound adjustment during recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SOUND
AUDIO ADJUST
GRAPHI
SHIFT
T-BASS
VOLUME
GEEQ
SHIFT
W
z
o
p
<
oe
<
a
u
K
a
Q
z
3
o
M
VOLUME
Turn VOLUME on the main unit, or press VOLUME on the
remote controi.
The volume level is displayed as a number from 0 to MAX (31).
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
i^j
(cancel)
To select with the remote control
press
T-BASS
while pressing
SHIFT.
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
This unit provides the following three different equalization curves.
ROCK:
Powerful sound emphasizing treble and bass
POP:
More presence in the vocals and midrange
CLASSIC:
Enriched sound with heavy bass and fine treble.
Press one of GRAPHIC EQUALIZER.
The selected equalization mode is displayed.
¿r
KuCv-:.
To cancel the selected mode
Press the selected button again. “GEQ OFF” is displayed.
To select with the remote control
Press
GEQ
repeatedly while pressing
SHIFT.
The GEQ mode is
displayed cyclically as follows.
ROCK-
POP-
CLASSIC-
GEQ OFF —I
(cancel)
1
To dim the illumination of the display
1
Press
CLOCK/DIMMER
twice so that “DIMMER” is displayed,
then press
II
SET
within 4 seconds.
2
Press ◄◄ or ►► repeatedly to select the dimmer mode as
follows.
C
DIMMER 1
■DIMMER 2-
DIM-OFF —I
(cancel) I
Press
II SET
within 4 seconds.
DIMMER 1;
The illumination of the display is dimmer than
usual, and the spectrum analyzer lights off.
DIMMER 2:
The illumination of the display is dimmer than
DIMMER 1, and the illumination on the buttons light off.
DIM-OFF:
The normal display is resumed.
Using the headphones
Connect headphones to the
PHONES
jack with a standard stereo
plug (
06.3
mm, V
4
inch).
No sound is output from the speakers while the headphones are
plugged in.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
ENGLISH
6