Figures, Grass catcher assembly – Bolens 122-336-120 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8.
Hook the end of engagement rod into idler
—bracket located inside slot on belt cover. See
figure 7.
9. Pull the engagement rod back until the idler
bracket is at the rear of the slot on belt cover.
FIGURE 7.
Ferrule
Locking
Ring (H)
Ferrule
Engagement Rod
10. With handle in the down position (released),
place ferrule (B) on threaded end of engage
ment rod. Thread ferrule onto engagement rod
until it lines up with the hole in lower handle.
11.---Place ferrule into hole in lower handle. Secure
------ with ferrule locking ring (H). See figure 8.
12.
Check
the
engagement
rod
adjustment.
Disconnect the spark plug wire from the spark
plug. Pull the recoil starter handle without
raising the mower handle. If the mower does
not move forward, adjustment is correct. If the
mower moves forward, remove the ferrule
locking ring from the ferrule and thread in or
out one turn. Repeat the above check as
necessary.
FIGURES.
Rear
Frame
Grass Catcher Assembly
1.
Connect the front and the rear frames by
— pushing the tubing connectors (M) onto the
ends of the frames. See figure 9.
FIGURE 9.