Aiwa NSX-A888 - Manual (Page 6)

I
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, repiace the batteries
with new ones.
To use SHIFT on the remote control
Buttons ® have two different functions. One of these functions
is indicated on the button, and the other on the piate above the
button.
To use the function on the button, simpiy press the button.
To use the function on the piate above the button, press the button
while pressing
SHIFT.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE/DECK1/
2, TUNER/BAND, VIDEO/AUX, CD, MD) on the main unit.
Each time FUNCTION is pressed, the next function is seiected
cyciicaliy. When tapes are inserted in both decks, each deck is
selected with
FUNCTION.
►/◄► PRESET on the remote control
The function is the same as that of on the main unit.
■ ENTER
To turn the power on
Press one of the function buttons (TAPE/DECK 1/2, TUNER/
BAND, VIDEO/AUX, CD, MD). Playback of the inserted disc or
tape begins, or the previously tuned station is received (Direct
Piay Function).
POWER is aiso avaiiable.
When the power is turned on, the disc compartment may open
and cióse to reset the unit.
To turn the power off
Press POWER.
To change the brightness level of the display
1 Press ECO so that “ECO MODE” is displayed.
2 Within 4 seconds, turn MULTI JOG to display “DIM MODE”,
and then press ENTER within 4 seconds.
3 Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will also
be set if ENTER is pressed within 4 seconds after step 3.
DIM-OFF-^DIMMER 1 ^ DIMMER 2*-» DIMMER 3
r
DIM-OFF: The normal display.
DIMMER 1: The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2.The spectrum analyzer, and the button lamps light
off.
■ If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
' The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
If the timer recording (page 27) is done with the economizing
mode (page?) set to “ON” and the power turns off, the dimmer
mode will be set to “DIMMER 3” the next time the power is
turned on.
6 ENGLISH