Picture a-8 – Buffalo Technology WLA-L11G User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
/it t^e
^/'yout
Page A-4
3) Go to the Apple icon in the top left corner of your Desktop screen.
Scroll down to "AirPort" and select. In the "Settings" section,
verify that "AirPort: On" is displayed, if it is not displayed, select the
"Turn AirPort On" button (Picture A-7).
In the "AirPort Network" section, go to "Choose network".
Click on the up/down symbols and select the AirStation's ESS-ID.
This will be a 6-digit alphanumeric followed by the word "GROUP".
Note: if Roaming was selected during setup of the WLA-L11G, you will
select "OOOOOOGROUP" beside "Choose network".
Close the AirPort Control Panel window.
[AirPort
_Status
8600BDGR0UP
Getting statue...
Signal level:
^ Settings
_AirPort.
AirPort: On
Turn AirPort Off I
AirPort ID: 00 30 65 10 3D 2D
Q Allow eelection of closed networks
_ AirPort Network
Choose network: 8600BDGR0UP
IJ
Picture A-7
4) If WEP was configured during setup of
the WLA-L11G, you will be prompted for
a Password (WEP code). Input the WEP
code in the box beside "Password" and
select "OK" (Picture A-8).
You should now be connected to your network.
the selected AirPort network requires a
password to join.
Password:
QAdd 10 Keychain
I Cancel I
I
OK
Picture A-8