Buffalo Technology WLA-L11G - Manual (Page 20)

14.3) Select "Return". You will be prompted for the password. Input the
password into the box beside "Password" and select "OK" (Picture 44).
Page 18
Connectto "1.1.1.1" as:
User ID:
Password:
root
Picture 44
Realm: SETUP
□ Remember Password Cancel I I OK |
15) Restricting which MAC addresses may access the WLA-L11G.
15.1) On the left side of the Advanced Settings screen, select "Wireless LAN
Restrictions" (Picture 45). Expanding
Routing
Packet Filter
Picture 45
^\^eless LAN Restriction!
AP Conununication
Radio Hardware Settings
15.2) Place a check in the box beside "permit connection" and select
"Change" to set your wireless computer's MAC address as an authorized
connection (Picture 46). Select "Return".
Note: if there is more than one MAC address showing at this point,
another computer is already connected to the WLA-L11G.
If this is the case, open your AirPort Control Panel to find your MAC address
beside "AirPort ID" (Picture 47). Place a check beside that MAC address
(Picture 46) only and select "Change". Select "Return".
wvktt LA?ifCt
MAC
tJCC fCt
MAC Ckmtf
00 W 2DO^#f*
Picture 46
Oi»»« I *■
AirPort ID: 00 30 65 10 3D 2D Picture 47