Buffalo Technology WLA-L11G - Manual (Page 13)

Page 11
8.3) Select "Enable", then "Set" (Picture 23). Select "Return".
Wlrelf ss LAN Rf itrictions Sfttingi
Restrict connection from wireless LAN PCs
® Enable
O Disable
Picture 23
m*)
8.4)
To allow other wireless computers to access the WLA-L11G, type each
MAC address (with every two Hexadecimal numbers separated by
a colon as shown) into the box beside "MAC address of wireless LAN
PC" and select "Add" (Picture
24).
Select "Return".
Each added computer will require the WEP code to access the WLA-L11G.
MAC addresses for AirPort Cards may be found in the Apple AirPort
Control Panel for each computer. MAC addresses of PCs are usually found
on the wireless card itself.
Add wii eless LAN PC to list of autlioiized PCs £
MAC addi'ess of wii'eless LANPC
L
|00:45:32:0D:76:32| Picture 24
Add
If only one WLA-L11G is being set up, you are finished with setup and
may close the browser.
Note: Setting up the second WLA-L11G.
If a second WLA-L11G is to be set up to communicate with the
first WLA-L11G, repeat steps 3.3-8.4 (OS9) for the second WLA-L11G.
During setup of the second WLA-L11G, the first WLA-L11G should have
the power disconnected. After completing setup of the second unit,
reconnect power to the first unit, and setup is complete.
Note: The ESS-ID (Wireless MAC Address) of the first WLA-L11G will be
used in the "Wireless LAN MAC Address" field for the second WLA-L11G
(Pictures, Page6).