Lubrication table – Bolens 2182 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LUBRICATION TABLE
Point of Lubrication
Check
at
Hours
Change
at
Hours
Capacity
AntlClplated Air Temperatijre
77°F and above
32°F to 77°F
32°F to 0°F
Engine crankcase
Check
before
each
use
35
and
100
approx.
3.4 qts
including
oil in
oil filter
Cub Cadet
Low Ash
Engine Oil
SAE 30W or
SAE10W-30
Engine Oil
SAE 20W or
SAE10W-30
Engine Oil
SAE 10W or
SAE10W-30
Hydro-drive unit
mounted on trans
mission case with
filter
Check
before
each
use
Add
as
needed
Approx.
14 pints
Cub Cadet Hydraulic Transmission Fluid
NOTE: Cub Cadet hydraulic transmission fluid meets
IH B-6 specifications. If fluid is used that does not
meet these requirements,Cub Cadet will not be respon
sible for substandard performance. Failures due to use
of improper fluid are not covered by warranty. For
maximum protection, use Cub Cadet Hydraulic Trans
mission Fluid.
Steering knuckles &
front axle pivot bolt
10
Use 251H EP grease or equivalent No.2 multi-purpose
lithium grease and apply two or three strokes or suffi
cient grease to flush out old grease and dirt.
Front wheel
bearings
35
Two or three strokes minimum of the lubricator using
251H EP grease or eqivalent No. 2 multi-purpose
lithium grease.
Alignment couplings
251H EP grease or equivalent No. 2 multi-purpose
lithium grease.
37